+86-577-27869969 / +86-18668777248‬        aliex@rockwill.com
News & Media
Home / News / Industry News / ​How does distribution step voltage regulator work?

​How does distribution step voltage regulator work?

Views:0     Author:Site Editor     Publish Time: 2021-09-21      Origin:Site

In the power supply, distribution step voltage regulators play a key role. A distribution step voltage regulator is used to regulate voltage levels. It acts as a buffer for protecting components from damages. It is used for protection of components from damages

 

What is the structure of distribution step voltage regulator?

How does distribution step voltage regulator work?

What should be paid attention to when using distribution step voltage regulator?

 

What is the structure of distribution step voltage regulator?

The structure of the distribution step voltage regulator is mainly composed of handwheel, intake pipe, upper valve cover, lower valve cover, rubber film, intake nozzle, valve pad, a small lever, outlet pipe and other parts.

In the middle of the distribution step voltage regulator is a circular rubber membrane, which divides the regulator into two upper and lower air chambers. There is a spring in the upper air chamber, connecting with the adjusting screw cover and the rubber film.

There is a small hole on the edge of the upper valve cover, which allows the upper air chamber to communicate with the outside. There is a lever made of fine brass in the lower air chamber with sensitive rotation performance.In the middle of the distribution step voltage regulator is a circular rubber membrane, which divides the regulator into two upper and lower air chambers. There is a spring in the upper air chamber, connecting with the adjusting screw cover and the rubber film.

The right end of the lever is connected to the center of the rubber film. The left end is glued to the valve pad and fastened to the intake nozzle to dampen the high-pressure petroleum gas sprayed.


distribution step voltage regulator

 

How does distribution step voltage regulator work?

The input of the distribution step voltage regulator gets from the power supply. It may vary, but the output of the distribution step voltage regulator is maintained constant according to the requirement of all remaining equipment.

A distribution step voltage regulator circuit is used to make as well as maintain a permanent output voltage even when the input voltage otherwise load conditions are changed. It gets the voltage from a power supply and can be maintained in a range that is well-suited with the remaining electrical components. Most commonly these distribution step voltage regulators are used for converting DC/DC power, AC/AC or AC/DC.

 

What should be paid attention to when using distribution step voltage regulator?

Before use, it must be ascertained that the grid voltage is consistent with the input voltage terminal button and the input terminal output must not be connected reversely. The distribution step voltage regulator should be connected to a protective ground wire. After the distribution step voltage regulator is used, the hand should be turned to the zero position and cut off power supply.

The power supply voltage should conform to the input voltage on the nameplate of the distribution step voltage regulator.

The distribution step voltage regulator is well-grounded to ensure safety.

When using, you should always pay attention to that the output power is lower than the rated value.

Rotate the handle slowly and evenly during use to avoid damage to the brush or sparks.

The use of the distribution step voltage regulator should be checked frequently. If the brush is found to be excessively worn or defective, it should be replaced in time.

 

Learn more about distribution step voltage regulator can know how distribution step voltage regulator works and the structure of distribution step voltage regulator. Wenzhou Rockwill Electric Co., Ltd. can offer you some solutions. If you have any needs, please leave us a message!


Rockwill T&D Group is a high-tech enterprise specializing in developing, manufacturing and marketing power transmission and distribution products.

QUICK LINKS

Home

Outdoor Breakers

CONTACT US

   Tel: +86-577-27869969
 Cel: +86-18668777248‬
  E-mail: aliex@rockwill.com
  Add: Wengyang Industrial Zone,Wenzhou City, Zhejiang Province,China.
Copyright © 2021 Rockwill T&D Group All Rights Reserved.